Cecil Whittaker’s Pizza Box Guitar

fullsizeoutput_658IMG_1587fullsizeoutput_664

I cut down the neck, glued it, and carved the Double Razorblade head design that is now the official Junk Shop Audio head. Then, I cut a channel in the neck for my Junk Shop Audio Nd144 pickup and stained the neck with a steel wool and balsamic vinegar blend that looks awesome.

IMG_1583fullsizeoutput_665

I cut a hole for the 1/4″ jack, along with removing part of the inner box. The jack works great, but care must be taken when inserting and pulling out the cord, as the wall is a bit weak.

IMG_1578IMG_1579

I installed a small piece of angle with three brass screws. and then added the simple machines—made of ground thumb screws and rod nuts—and a bridge made of cut brass rod, filed flat on the bottom. To hold the box closed, I used the strap button, which is made of a brass knurling nut and a vandal-proof bolt—when this is removed the box opens.

IMG_1592

For the head, I used stainless bolts, brass washers, and brass knurl nuts to hold the strings in place and a cut bolt for the nut. For the frets I went in a new direction—after marking the fret distances, I cut small grooves into the top corner of the neck to mark the fret positions. These small grooves can be seen from both the front and side, so it is visible from all angles. I like the subtle look of these markers.

fullsizeoutput_667IMG_1591

Acoustically, the guitar is not super loud, but it’s great for jamming out in the driveway after hours; amplified, it sounds great.

Thanks,

img_1926-2

Advertisements